Re: Convert Uniden 200 XLT

Posted by Dave Geno on September 13, 1997 at 08:03:04:

In Reply to: Re: Convert Uniden 200 XLT posted by Al on May 22, 1997 at 23:33:05:

: : Anyone know how to unlock this scanner.

: : Thanks for any help
: : Chris

: When you pull the scanner apart and get to the
: main circuit board, you'll see a big chip labeled
: 'UNIDEN UC-1147A'. If the scanner is held in a
: vertical position, look directly to the left of
: the 'DEN' and you'll see either a small resistor
: with 3 stripes on it OR a small flat black resistor
: with '103' on it. Just take out the resistor or
: cut through it with small scissors, and that's it.

To access the circuit board, there are two screw on the back, and two on the bottom of the case. There is also what feels like a screw hole on the back, under the serial tag label. Does this screw have to be removed as well?
Thanks...

Follow Ups:

Post a Followup

Name:

E-Mail:

Subject:

Comments:
: : : : Anyone know how to unlock this scanner. : : : Thanks for any help : : : Chris : : When you pull the scanner apart and get to the : : main circuit board, you'll see a big chip labeled : : 'UNIDEN UC-1147A'. If the scanner is held in a : : vertical position, look directly to the left of : : the 'DEN' and you'll see either a small resistor : : with 3 stripes on it OR a small flat black resistor : : with '103' on it. Just take out the resistor or : : cut through it with small scissors, and that's it. : To access the circuit board, there are two screw on the back, and two on the bottom of the case. There is also what feels like a screw hole on the back, under the serial tag label. Does this screw have to be removed as well? : Thanks...

[ Follow Ups ] [ Post Followup ] [ INTERCEPT WWW BBS ]