In Reply to: Pro-2035 Descriminator output posted by Lonnie Gorsline on April 24, 1997 at 21:03:28:
: I would like to add a descriminator out put to my Pro-2035. Does anyone have the information to do such a thing?
: Thanks in advance
: Lonnie
Lonnie-
You will need to tap pin 9 on the IF AMP/Detector chip. It is going to have TK10420 on the top of the chip. It is going to be located on the middle of the RF/Linear board(the one that runs horizontal in the scanner). Don't solder directly to the pin because you get the same connection at Test Point 2(TP2) which is a peg right near it. Wire that connection to the center hub of a 1/8" jack or something simular and have the other connection grounded.