InterceptRadio.com Forums

Looking for mobile to station freq for Hyak. Seattle (Hyak) transmitting on 155.580, mobiles unknown.
Maybe it's set up like Skykomish (Everett),
154.845 Skykomish/ 154.755 mobiles, only w/ different freq's.
I'll try the Seattle input (158.790) and see if that's it.
Somebody must have this one.
- Jay.

I thought sno Pass was on 154.77. The input to WSP King north is 154.785. I think that 158.79 is one of the two inputs for Kitsap WSP - along with 159.075 to a 154.665 output.

-m

158.790 100.0hz

154.770 was Snoq pass area back before Ellensburg and Seattle got a repeater. ( Back when you could hear 460.325 up there).
icom 1020, to verify, 158.790 is Hyak input to Seattle?
I know on Stevens there is a State repeater, or was a couple years ago, it would simucast on Everett area.

I think I see your point when they used to say "hyak" on the radio. Is that what you meant? Because I used to hear that too. I don't listen to the F3 area much unless I'm up there. Is "hyak" the dodge ridge site or something else, Ellensburg looks to be "Stampede" maybe someone can clarify My printout sez :

Squak Mtn F6-F3 Voted repeater 155.58/158.790 red 100.0
Rattlesnake F6-F3 Voted Half duplex base station 155.58/158.790 red 100.0

So maybe you're correct about the repeater part of the Sno Pass site It appears to be duplex 155.580/158.790 remote, the map symbols say its not a repeater, so now I'm confused.

So to answer your question, yes it is the input back to "Seattle" but for us to listen to units up on the pass I'm not sure what the setup is .

this is from a late 90's ESD map, I need a newer one

I'll try it next Sunday when I go to Ellensburg.
Ironicly icom1020, I'm programing an icom. (V8000).
A couple days ago, down here in the lowlands, I heard on 155.580 a unit say xxx- Hyak: "clear (something) milepost 59, road & weather at Hyak: 35 deg., roadway wet". Then Seattle acknowledged.
Cheers, Jay.