| InterceptRadio.com Forums http://www.interceptradio.com/bbs/ |
|
| decoding Shure ULX-D http://www.interceptradio.com/bbs/viewtopic.php?f=1&t=8438 |
Page 1 of 1 |
| Author: | gregz [ Fri Apr 01, 2016 12:37 pm ] | ||
| Post subject: | decoding Shure ULX-D | ||
has anyone found a hardware or software that will decode Shure ULX-D digital transmissions? most of the time they are run un-encrypted.  attached a screen shot of the transmission. it's 200 KHz wide, nice straight sides. thanx
|
|||
| Author: | nickcarr [ Sat Apr 02, 2016 11:30 pm ] |
| Post subject: | Re: decoding Shure ULX-D |
AES 256-bit encryption equipped for secure wireless transmission Good luck. :) The audio is using this form of encoding and you would need to find a setup that can decode it: https://en.wikipedia.org/wiki/Dante_(networking) FYI, it sounds like the custom Shure application can decode it: http://www.shure.com/americas/products/ ... orkbench-6 |
|
| Author: | gregz [ Sun Apr 03, 2016 1:16 pm ] |
| Post subject: | Re: decoding Shure ULX-D |
Most of the time the transmission is run un-encrypted because it makes it easier to work with. The Wireless Mic Tech doesn't need to exchange keys to switch between hand held, and lav pack transmitter. If it's un-encrypted you just need to turn off the hand held, and turn on the lav pack. Dante can only decode the Dante audio network coming out the the back of receiver via RJ45. It is not the codac that the transmitter is using. Dante is a transport protocol out of the receiver and into the sound mixing console. Shure's Wireless Workbench is similarly handicapped that it can't decode any audio. It's just a remote management software used to set up the radios. |
|
| Author: | soundman [ Sun Apr 03, 2016 9:08 pm ] |
| Post subject: | Re: decoding Shure ULX-D |
I can sell you a hardware solution that will decode that unencrypted transmission. $875 plus tax shipped to you. |
|
| Author: | gregz [ Mon Apr 04, 2016 4:48 am ] |
| Post subject: | Re: decoding Shure ULX-D |
I"m looking for something other then a ULX-D receiver. You would need 5 x $875 in ULX-D receivers to receive all 5 bands: G50, H50, J50, L50 and X52. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Copyright © 2013 Interceptradio.com |
|